Discuz! Board

查看: 65|回复: 0

eyy757 copper pipe bendercopper punch









Rank: 2

发表于 2020-5-27 02:14:57 | 显示全部楼层 |阅读模式
Hydraulic punch presses have pressurized hydraulic fluid that is pumped to the ram via a cylinder. A typical hydraulic punch press doesn’t have a flywheel. It runs by the pressure of the fluid. It is useful for conditions where a consistent pressure is required and a large range of strokes. Contrary to the popular belief,copper busbar twisting machine, it can be used for faster-running processes as well. However, the ability of running deep draw parts vanishes as the speed increases. If proper force is not maintained, then there are chances of over exertion. It may cause damage to the press and die by ripping the bottom.
Historic and forecast market value by construction activity (new construction,busbar punching cutting line, repair and maintenance,copper busbar punching machine, refurbishment and demolition) across the waste processing plants construction industry for the period 2010 through to 2019.
Second, check the chloride ion content: (1) Low chloride ions, chloride ions can not be full price of copper ions with a combination of copper in the formation of divalent copper ions in the process can not be a full price of copper ions (chloride copper) into divalent copper ions (copper sulfate), the formation of , plating caused by rough; Cl reduction is mainly from the large anode area and caused a small cathode area. That term in the large tank or bath plating excessive number of small sample size and small size board. Small cathode copper (II) ions required for less,bus duct machine, while the anode is relatively more cuprous chloride deposited on the anode, or is likely to fall off and sedimentation caused by continuous filtration to remove chlorine ions in the bath reduced. (2) High when chloride ions, the formation of excess cuprous chloride, cuprous chloride ions such excess will produce disproportionate reaction, the formation of copper powder, copper plating caused rough. Increased levels of chloride ions mainly from clean water, add water. (3) The midpoint of the control of chloride ions 55ppm,busway machine, the control range of 40 ~ 65ppm, when less than 35ppm, we should start adding chlorine ions; high 75ppm when the chloride ion, we should do to reduce chloride preparations. Source:http://www.mhcmp.


使用道具 举报

您需要登录后才可以回帖 登录 | 立即注册



GMT+8, 2020-7-6 00:47 , Processed in 0.109200 second(s), 18 queries .

Powered by Discuz! X3.4

Copyright © 2001-2020, Tencent Cloud.

快速回复 返回顶部 返回列表